Chicago-electric 90 AMP FLUX WIRE WELDER 68887 User Manual download pdf (Page 11)

Page 11For technical questions, please call 1-800-444-3353.Item 68887

16. To check the wire’s drive tension, feed the wire

against a piece of wood from 2 to 3 inches away. If

the wire stops instead of bending, turn the Welder

to OFF, unplug it, slightly tighten the Feed Tensioner

clockwise , and try again.

If the wire bends from the feed tension,

then the tension is set properly.

17. TURN THE WELDER TO OFF.

18. Select a Contact Tip that is compatible with the

welding wire used. The included Tip (0.030")

will work with 0.030" flux-core wire only. To

use 0.035" wire install a 0.035 tip (both sold

separately). Slide the Contact Tip over the

wire and thread it clockwise into the Gun.

19. Replace the Nozzle and cut the wire

off at

" from tip (

" stickout).

20. Swing the Cover closed until the

Cover Latch locks in place.

.030″

2-3″

Incrementally

increase tension

until

wire bends.

ON MIN

OFF MAX

WIRE FEED SPEED

GUN

GROUND

120V~

60Hz

20A

90 AMP FLUX WIRE WELDER

ITEM 68887

Specications

Wire 0.030" – 0.035" Flux-Core

Capacity 18 Ga. – 3/16" Steel Plate

Weldable

Materials

Mild, Low Alloy Steel

(Not for Aluminum or Stainless Steel)

Gun

Nozzle

Contact

Tip

SAFETYMAINTENANCE BASIC WELDINGWELDING TIPS SETUP

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

Donnie 22 Feb 2024 | 03:34:56

I need The Wire diagram for the current switch.

Raymond Korczak 22 Aug 2024 | 00:56:48

What manufacturer can I purchase a new contact tip from?

Chicago-electric 90 AMP FLUX WIRE WELDER 68887 User Manual Page 11

Comments to this Manuals

Related products and manuals for Tools Chicago-electric 90 AMP FLUX WIRE WELDER 68887