Chicago Electric 69334 Owner's Manual download pdf (Page 11)

Page 11For technical questions, please call 1-888-866-5797.Item 69334

Chiseling

Changing Chisel Bits

1. Grease the bit shank before installing.

2. Pull back on the Chuck and insert the Bit. Make

sure it slides all the way into the opening.

3. Release the Chuck.

4. Rotate the Mode Selector so the Adjust

Chisel Setting is in the ON position. Rotate

the bit to the desired angle then rotate the

Mode selector to the Hammer setting.

5. Check that the bit is secured in place. It should

not be able to be pulled out of the Chuck.

Chisel Operation

1. Adjust the Auxiliary Handle as needed.

2. Plug in the Power Cord.

3. Squeeze and hold the Trigger to

turn on the Rotary Hammer.

4. Allow the Rotary Hammer to reach full speed

before contacting the work surface.

5. When finished, to prevent accidents, release

the Trigger and disconnect its power supply

after use. Pull back on the Chuck then remove

the bit from the Chuck. Clean, then store

the tool indoors out of children’s reach.

SAFETYOPERATIONMAINTENANCE SETUP

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Chicago Electric 69334 Owner's Manual Page 11