Chicago Electric 66615 Specifications download pdf (Page 16)

Page 16 For technical questions, please call 1-888-866-5797. Item 66615

SAFETY OPERATION MAINTENANCESETUP

Maintenance and Servicing

Procedures not specifically explained in this manual must

be performed only by a qualified technician.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Make sure that the Power Switch is in the off-position and unplug the tool from

its electrical outlet before performing any procedure in this section.

TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:

Do not use damaged equipment. If abnormal noise or vibration occurs,

have the problem corrected before further use.

Cleaning, Maintenance, and Lubrication

1. BEFORE EACH USE, inspect the general

condition of the tool. Check for:

• loose hardware,

• misalignment or binding of moving parts,

• damaged cord/electrical wiring,

• cracked or broken parts, and

• any other condition that may

affect its safe operation.

2. AFTER USE, wipe external surfaces

of the tool with clean cloth.

3. Remove the Bonnet from the tool when not in use.

This will allow the Bonnet to dry and retain

its original shape. The Bonnets may be

machine-washed in cold water with detergent.

Then machine-dry the Bonnets at medium heat.

4. Periodically, wear ANSI-approved safety goggles

and NIOSH-approved breathing protection

and blow dust and grit out of the motor

vents using dry compressed air.

WARNING! If the supply cord of this

power tool is damaged, it must be replaced

only by a qualified service technician.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Chicago Electric 66615 Specifications Page 16