Chicago Electric 95573 Owner's Manual download pdf (Page 5)

Page 5For technical questions, please call 1-888-866-5797.Item 95563

Cleaning With Heat

1. Press the “TC” Button to use the heat function

during a cycle of the Ultrasonic Cleaner. A

red light on the control panel will light up,

indicating that the Heat cycle is on.

2. On some occasions, the initial cleaning may not

adequately clean the article. A second cycle of

cleaning usually finishes the cleaning process.

Pressing the “ON” Button will restart the cycle.

Note: The Ultrasonic Cleaner has an automatic safety

shut-off to avoid overheating. To prevent overheating

and damaging the product, do not use more than

3 cycles in a fifteen minute period. This automatic

safety shut-off will be activated after 45 minutes of

continuous use. Should this happen, allow the unit

to cool off for fifteen minutes before resuming use.

3. To pause or stop the cycle, press “OFF”.

4. When finished, unplug the Ultrasonic Cleaner.

Open the lid and carefully remove the item

using tongs because the fluid will be hot.

OFF

SET

ON OFF SET TC

Figure 1: Control Panel

Troubleshooting

Problem Possible Causes Probable Solutions

Cleaner will not start 1. No power at outlet.

2. Cord not connected.

3. Automatic overheating safety

shut-off feature has tripped.

1. Check power at outlet.

2. Check that cord is plugged in.

3. Allow fifteen minute cool-down

period before attempting to use

the Ultrasonic Cleaner.

1 2 3 4 5 6 7 8

No comments

Chicago Electric 95573 Owner's Manual Page 5